Angle 90 O2 Oxygen
Sensor Extender Spacer for Decat Hydrogen Brass
Foreword:
90
angled Lambda Oxygen Sensor Extender
In
vehicles with EURO 3 and higher vehicle emissions standards the second
lambda oxygen sensor emulator is located after the catalytic converter. It
plays a diagnostics role.
If
it detects any irregularities on the basis of the data from the engine
control unit it displays an error on the dashboard (a popular “CHECK
ENGINE”) and the engine can switch into emergency mode (depending on the
make of car).
It is
often manifested by big power drop. These problems arise in the event of
removal of the catalyst, its low efficiency, or its replacement with jet
pump.
In such
situations, it becomes necessary to mount THE SECOND LAMBDA OXYGEN SENSOR
EXTENDER.
The
catalyst can effectively reduce the power output of 2 to 3%, and the maximum
power speed of up to 5%. Its removal and the use of emulator is the easiest
way to low-cost raise of power.
The
emulator can also help in case of problems with the LPG installation, which
due to the detection of very rich mixture will display the CHECK ENGINE on
the dashboard.
Technical
Specifications:

Brand-new, unused, unopened and undamaged
Extenders
are from brass
Internal
and external thread M18x1.5
Height 40
mm
Polished
front surfaces enabling perfect tightening
Washer in
the set – ability to adjust the angle of screwing in the extender
Threads
made with dedicated tool – perfect accuracy and repeatability
Exhaust
gas inlet hole 2 mm. In extreme situations narrowing of the inlet hole
prevents motor failure (driving at high speed)

Professional quality of manufacturing

Installation is very simple. Unscrew the lambda oxygen sensor, screw in the
emulator in its place and then screw in the oxygen sensor.
Perfect
for tight awkward spaces, where there is no room for the straight extenders
Package
included:
1 set
Angle 90 O2 Oxygen Sensor Extender Spacer